Omron NJ501-1300 - Using the FTP Server Function

10-5
10 FTP Server
NJ-series CPU Unit Built-in EtherNet/IP Port User’s Manual (W506)
10-3 Using the FTP Server
Function
10
10-3-1 Procedure
10-3 Using the FTP Server Function
1 Make the basic settings.
Refer to 1-5-1 Outline for basic operations.
2 Set up the FTP server on the Sysmac Studio. (Refer to 5-3 FTP Display.)
3 Select Built-in EtherNet/IP Port Settings under Configuration − Controller Setup on the
Sysmac Studio. Make the following settings on the FTP Settings Display.
• FTP server
• Port number
• Login name
• Password
4 Place the CPU Unit online and transfer the settings to the Controller.
5 Insert the SD Memory Card into the CPU Unit.
6 Connect to the built-in EtherNet/IP port from an FTP client.
7 Input the FTP login name and password that you set in the Built-in EtherNet/IP Port Settings to
log in to the built-in EtherNet/IP port.
Note Once logged in, the ftp commands can be used, such as cd (Change Directory), and get (Obtain
File).
8 Look for the target file on the SD Memory Card that you inserted into the Controller in the
MEMCARD1 directory.
9 Download the files.
10 Close the connection.
Make the following settings for the unit setup when the FTP server function is used.
* Settings are not required if the FTP server is not used.
10-3-1 Procedure
10-3-2 List of Settings Required for the FTP Server Function
Built-in EtherNet/IP Port
Settings Tab Page on
Sysmac Studio
Setting Setting conditions Reference
FTP FTP server Required page 10-6
Port No.
Optional
*
Note Required when
changing the default
value of 21.
Login name
Required
*
Password
Required
*