1 Introduction
1-16
NJ-series CPU Unit Built-in EtherNet/IP Port User’s Manual (W506)
1-5 EtherNet/IP Communications
Procedures
z Basic Operation
z Using Tag Data Links
1-5-1 Outline
1
Wire the Ethernet network with twisted-pair cable.
Section 2 Installing Ethernet
Networks
↓
2
Set the built-in EtherNet/IP port IP address with the Sysmac Studio.
Section 4 Determining IP
Addresses
1. Use the Sysmac Studio to create a new project.
2. Set the local IP address in one of the following ways:
• Default: 192.168.250.1 (subnet mask = 255.255.255.0)
• Set any IP address.
• Obtain from BOOTP server.
↓
3
Use the Sysmac Studio to set the initial settings of the EtherNet/IP
Function Module.
Section 5 Sysmac Studio
Settings for the Built-in Eth-
erNet/IP Port
Set the TCP/IP settings and Ethernet settings as required.
↓
4
Turn the power ON, and connect the Sysmac Studio online.
↓
5
Perform a communications test with a PING command from a com-
puter.
Section 6 Testing Communi-
cations
1
Use Network Configurator to create the tag data link table.
Section 7 Tag Data Link
Functions
• Create the network configuration.
• Set the connections.
↓
2
Turn the power ON, and connect the Network Configurator online.
↓
3
Download the tag data link setting.
↓
4
Start the tag data links (the links starts automatically when power is
turned ON).
To Next Page
Loading...
