12 SNMP Agent
12-22
NJ-series CPU Unit Built-in EtherNet/IP Port User’s Manual (W506)
z SNMP
12-2-3 SNMP Settings Display
Setting Description Default
SNMP Specify whether to use the SNMP monitor service. If the SNMP
monitor service is not enabled, an SNMP manager cannot connect
from an external device.
Do not use.
Port No. Set the port number to use to connect to the SNMP server that is
used to connect from an SNMP manager. It is normally not neces-
sary to change this setting.
161
Address Set the communications device administrator name and installation
location as text information. You do not necessarily have to input all
items. This information is read by the SNMP manager. (You can
input up to 255 alphanumeric characters for each item.)
None
Location None
Send a recognition
trap
Set whether to send a recognition trap. If you select the
Send a rec-
ognition trap Check Box and there is access from an SNMP man-
ager that is not set in Recognition 1 or Recognition 2, a recognition
trap is sent to the SNMP manager. If you enable the send a recogni-
tion trap, specify the SNMP trap settings on the SNMP Trap Tab
Page.
Do not use.
To Next Page
Loading...
