Omron NJ501-1300 - Page 295

12-25
12 SNMP Agent
NJ-series CPU Unit Built-in EtherNet/IP Port User’s Manual (W506)
12-2 Procedure to Use the SNMP Agent
12
12-2-4 SNMP Trap Settings Display
z Trap 2
*
* These settings are required if the SNMP trap is set is enabled.
Setting Description Default
Trap 2 Specify whether to use the trap 2 settings.
• Use.
• Do not use.
Do not use.
Specifying method Set the specifying method for the SNMP manager destination
for SNMP traps.
• IP address
• Host name
IP address
IP address Set the IP address of the SNMP manager. (Set this setting if
the specifying method in the trap 2 settings is set to the
IP
address Option.)
None
Host name Set the host name of the SNMP manager. (Set this setting if
the specifying method in the trap 2 settings is set to the Host
name Option.) (You can use up to 200 single-byte alphanu-
meric characters, dots, and hyphens with up to 63 single-byte
alphanumeric characters between dots.)
None
Community name Set the community name. (You can use up to 255 single-byte
characters.)
public
Version Set the version of the SNMP manager.
• SNMP version 1: SNMPv1
• SNMP version 2C: SNMPv2C
SNMPv1