4-1SectionOperation of the Memory Link
371
• PT memory write command Page 381
• Numeral memory table write command Page 382
• Character-string memory table write command Page 383
• Bit memory table write command Page 384
• PT memory batch write (FILL) command Page 386
• Numeral memory table clear command Page 386
• Character-string memory table clear command Page 387
• Bit memory table clear command Page 388
Notify Commands
These commands serve to notify the host of the results of operation at the PT.
Only these commands are issued by the PT and, therefore, there is no response
for them.
There are the following five commands.
• Touch switch input notify command Page 389
• Numerical input notify command Page 390
• Character string input notify command Page 391
• Direct area changing notify command Page 392
• PT memory changing notify command Page 394
Operation Mode Switching Command
This command switches the PT operation mode from RUN mode to transmit
mode. It is issued from the host and switches the PT operation mode.
• PT operation mode switching command Page 395
Re-send Command
This command lets the PT re-send a notify command. It is issued from the host
and the notify command issued last is re-sent from the PT.
• Re-send request command Page 396
Error Response
This is a response from the host that is issued when the contents of command
transmitted to the PT was incorrect.
• Error response Page 396
To Next Page
Loading...
