3-2SectionBuzzer, Backlight, and Display Control
297
Set 0 (OFF) for bit 15 in the fourth word (n + 3 words) from the beginning of the PT
status control area.
3-2-5 Redisplaying the Turned-off Screen
The following operations redisplay the screen that has been turned off by the
screen saver function or due to the operation at the PT status control area.
• Switching the displayed screen (the new screen is displayed normally)
• Operation at the PT status control area (the previously displayed screen is re-
displayed)
• Pressing the touch panel (the previously displayed screen is redisplayed)
Redisplaying the Screen by Switching the Displayed Screen
If this method is used, no special operation is necessary to redisplay the screen.
The screen is redisplayed automatically.
No special setting is necessary.
Switching the screen during operation of the PT cancels the screen off status
and displays the new screen. For the procedure for switching the screen, refer to
3-3-1 Switching the Screen (page 299).
Redisplaying the Screen by the Operation at the PT Status Control Area
This method allows the operator to redisplay the screen at any required time.
PT
Redisplaying the screen
← Control data
PC
PT status control area
Screen switch setting
PT status control setting
Reserved for system use
Copy memory
table entry setting
Words must be allocated for the PT status control area in the host. No special
settings are required for the control of buzzer.
Setting
Operation
Setting
To Next Page
Loading...
Need help?
General
