7 Programming
7 - 58
NX-series Safety Control Unit User’s Manual (Z930)
Use the following procedure to edit jump labels.
Method: Select the jump label on the network and edit it.
• The jump label becomes editable when you click it. After you finish editing, press the Enter Key.
• Selecting Jump Labels
• After Jump Label Is Edited
Use one of the following procedures to insert a Jump instruction in a network.
Method 1: Drag Jump from the Toolbox to the words Start here on a new network.
Method 2: Right-click the FBD network and select Insert Jump from the menu.
• The Jump instruction is inserted in the network.
• Before Jump Instruction Is Dropped
Editing Jump Labels
Inserting Jump Instructions
To Next Page
Loading...
