6 System Configuration and Setup
6 - 2
NX-series Safety Control Unit User’s Manual (Z930)
6-1 Configuration and Setup Procedures
This section describes the procedures for using the Sysmac Studio to configure and set up the safety
control system.
Make the settings in the following order.
1. Slave Terminal Configuration and Settings
2. Configure and set up the safety network (FSoE).
3. Select the connected input devices and output devices to set up the input terminals and output ter-
minals.
4. Register the device variables.
5. Expose the variables to the NJ/NX-series CPU Unit.
To Next Page
Loading...
