29
Unit Versions
NX-series Safety Control Unit User’s Manual (Z930)
In this example, “Ver.1.0” is displayed next to the Unit model.
The following items are displayed.
• Slot number
• Unit model number
• Unit version
• Serial number
• Lot number
• Hardware version
• Software version
The software version is displayed only for Units that contain software.
The functions that are supported depend on the unit version of the Unit. The version of Sysmac Studio
that supports the functions that were added for an upgrade is also required to use those functions.
Refer to A-15 Version Information on page A-87 for the functions that are supported by each unit ver-
sion.
Unit Versions and Sysmac Studio Versions
To Next Page
Loading...
