Omron NX-SID800 User Manual

8 - 5
8 Checking Operation and Actual Operation
NX-series Safety Control Unit User’s Manual (Z930)
8-1 Procedures before Operation and Transferring the Required Data
8
8-1-1 Commissioning Procedure
Sysmac Studio
Safety CPU Unit
Setup and
Programming View
NJ/NX-series CPU
Unit Setup and
Programming View
Safety CPU Unit Setup and Programming View
Creating the
safety programs
Transferring the Slave
Terminal configuration
information
Checking operation
and safety validation
testing
Steps 1 and 2 Step 3
Steps 4 and 5
Step 6
Controller −
Synchronization
Controller − Safety
Validation
Operation
Step 7
Controller − Mode −
RUN Mode
Safety programs
(before
performing safety
validation)
Safety programs
(before
performing safety
validation)
Safety programs
(before
performing safety
validation)
Configuration
information
transferred.
Slave Terminal
Safety CPU Unit
Non-volatile memory
Non-volatile memory
Safety CPU Unit
Main memory
Safety CPU Unit
Main memory
Safety CPU Unit
Main memory
Operation
commands
Safety CPU Unit
Main memory
Non-volatile memory
Non-volatile memory
Safety programs
(before
performing safety
validation)
Safety programs
(before
performing safety
validation)
After stopping,
safety validation
is performed.
Safety programs
(after performing
safety validation)
Safety programs
(after performing
safety validation)
When you perform
safety validation,
the safety
programs are
transferred to the
non-volatile
memory.
Safety programs
(after performing
safety validation)
Sysmac Studio
Sysmac Studio
Sysmac Studio
Sysmac Studio
Sysmac Studio
Changing to DEBUG mode
(transfer program to main
memory)
Performing safety validation
(transfer program to
non-volatile memory)
Controller − Mode −
DEBUG Mode
Controller – Debug –
Start
When you change to
DEBUG mode, the
safety programs are
transferred to the
main memory.
Operation commands
in DEBUG mode.

Omron NX-SID800 Specifications

General

Brand	Omron
Model	NX-SID800
Category	Controller
Language	English