Omron OMNUC G5 Series

Index
I
6
OMNUC G5-series AC Servomotors and Servo Drives User’s Manual (with Built-in EtherCAT Communications)
Damping Filter 1 Setting (3215 hex).................. 9-18
Damping Filter 2 Setting (3217 hex)
.................. 9-18
Damping Filter 3 Setting (3219 hex)
.................. 9-19
Damping Filter 4 Setting (3221 hex)
.................. 9-19
Damping Filter Selection (3213 hex)
................. 9-17
Damping Frequency 1 (3214 hex)
.................... 9-18
Damping Frequency 2 (3216 hex)
.................... 9-18
Damping Frequency 3 (3218 hex)
.................... 9-18
Damping Frequency 4 (3220 hex)
.................... 9-19
Notch 1 Depth Setting (3203 hex)
..................... 9-15
Notch 1 Frequency Setting (3201 hex)
.............. 9-15
Notch 1 Width Setting (3202 hex)
..................... 9-15
Notch 2 Depth Setting (3206 hex)
..................... 9-16
Notch 2 Frequency Setting (3204 hex)
.............. 9-16
Notch 2 Width Setting (3205 hex)
..................... 9-16
Notch 3 Depth Setting (3209 hex)
..................... 9-16
Notch 3 Frequency Setting (3207 hex)
.............. 9-16
Notch 3 Width Setting (3208 hex)
..................... 9-16
Notch 4 Depth Setting (3212 hex)
..................... 9-17
Notch 4 Frequency Setting (3210 hex)
.............. 9-17
Notch 4 Width Setting (3211 hex)
..................... 9-17
Position Command Filter Time Constant
(3222 hex)
................................................... 9-20
W
warning list....................................................... 12-5
Warning Outputs (WARN1 and WARN2)
............... 3-22
wiring conforming to EMC Directives
..................... 4-20
Z
Zero Speed Detection Output (ZSP) ..................... 3-22