Typical Setting of Accel Time
Either DRIVE or PRGM mode can be selected.
DATA
ENTER
DSPL
RESET
(Setting prior to shipment : )
(Example of 12.5 seconds set : )
DATA
ENTER
(1) Depress key to select accel time constant .
(2) Depress key to display internal data of accel time constant.
The time can be set up to 6000 seconds in multiples of 0.1 second.
(4) Depress key to store the data.
If display reads end for approx.
1 sec, data has been accepted.
(3) Set required acceleration time by using , or key.
# #'
Section 3-5
To Next Page
Loading...
Need help?
General