Omron SYSDRIVE 3G3XV-EV2 Series - Page 13

9
200-V single-phase series, 3/5 HP (2.2/3.7 kW):
L
1
(R)
L
2
(S)
B
1
/⊕ B
2
T
1
(U)
T
2
(V)
T
3
(W)
Molded-case Circuit Breaker (MCCB)
Be sure to connect MCCBs between the power supply and 3G3XV
input terminals L1 (R), L2 (S), L3 (T). Recommended MCCBs are
listed in the tables below.
When a ground fault interrupter is used select the one with no influ-
ence for high frequency. When using an ordinary type, the setting
current should be 200 mA or over per Unit and operating time,
0.1 sec or over to prevent malfunction.
Molded-case Circuit Breakers and Magnetic Contactors
200-V-class 3-phase Input Series:
3G3XV
Model
3G3XV--EV2
A2001 A2002 A2004 A2007 A2015 A2022 A2037
3G3XV
Capacity (kVA) 0.3 0.6 1.1 1.9 2.5 4.2 6.7
Rated output current (A) 0.8 1.5 3 5 6.5 11 17.5
Molded-case Circuit Breakers 5 A 5 A 5 A 10 A 20 A 20 A 30 A
200-V-class Single-phase Input Series:
3G3XV
Model
3G3XV--EV2
AB001 AB002 AB004 AB007 AB015 AB022 AB037
3G3XV
Capacity (kVA) 0.3 0.6 1.1 1.9 2.5 4.2 6.7
Rated output current (A) 0.8 1.5 3 5 6.5 11 17.5
Molded-case Circuit Breakers 5 A 5 A 10 A 20 A 20 A 40 A 50 A
400-V-class 3-phase Input Series:
3G3XV
Model
3G3XV--EV2
A4002 A4004 A4007 A4015 A4022 A4037
3G3XV
Capacity (kVA) 0.8 1.2 2.0 3.0 3.7 6.1
Rated output current (A) 1 1.6 2.6 4 4.8 8
Molded-case Circuit Breakers 5 A 5 A 5 A 10 A 10 A 20 A
Surge Absorber
The surge absorbers should be connected to the coils of relays,
magnetic contactors, magnetic valves, or magnetic relays. Select
the type from the table below.
Surge Absorbers
Coils of magnetic contactor and control relay Surge absorber (see note)
Model Specifications
200 to 230 V Large-size magnetic contactors DCR2-50A22E 250 VAC, 0.5 µF + 20 Ω
Control relay
LY-2, -3 (OMRON)
MM-2, -4 (OMRON)
DCR2-10A25C 250 VAC, 0.1 µF + 100 Ω
400- to 460-V Units DCR2-50D100B 1,000 VDC, 0.5 µF + 220 Ω
Note Made by MARCON Electronics. Marketed in Japan.
Wiring Section 1-4