Omron SYSDRIVE 3G3XV-EV2 Series

29
2-2 Function/Constant Setting
DRIVE Mode and PRGM (Program) Mode
Selection of DRIVE Mode or PRGM Mode can be performed by
using the
PRGM
DRIVE
Key when the Inverter is stopped. When function
selection or a change of set value is required, switch to the PRGM
Mode.
DRIVE Mode
•Operation is enabled.
•Operations can be performed with the RUN, STOP, JOG, or
FWD/REV Keys.
•Frequency reference, jogging frequency, accel/decel time set-
ting, and frequency reference gain/bias values can be changed
during running.
PRGM Mode
•Program (function selection, constant setting) can be changed.
Display contents of the Digital Operator differ according to
selected Mode (PRGM/DRIVE).
The constant group to be displayed is changed each time display
selection key (the NO/DSPL Key) is pressed.
Frequency reference, jogging fre-
quency, accle/decel time setting,
and frequency reference gain/
bias value displays
Power on
DRIVE MODE
PRGM MODE DRIVE MODE
No. 
Output frequency monitor display
Output current monitor display
No.  reading
DRIVE
RESET
Mode switchable only when stopping
If a fault occurs, the
contents are dis-
played.
Fault reset
Refer to 2-7 Function/
Constant List
Display Contents of
DRIVE Mode and
PRGM Mode
Function/Constant Setting Section 2-2