Omron SYSMAC C Series User Manual

Checking and running your program
7. Press the button or buttons on the tape recorder that begin the
recording.
8. Then within 5 seconds press
REC
on
the
programming
console
keyboard.
A
blinking
rectangle
appears
in
the
right
corner
of
the
display.
This
means
the
program
is
being
saved
to
the
tape.
9. Wait about 7 minutes.
The program is being saved from the first program address to the end of
the RAM/EPROM memory area. The PC display increments as each
address goes into the cassette recorder. During this period you can halt
the save operation by pressing
CLR
10. When the program (plus vacant memory) has been completely
recorded, the save operation stops with this message.
Refer to this flowchart for the correct procedure when saving your
program to the cassette recorder.
(1) (Error takes place.}
Confirm the error
contents
START
L ia
Insert Cassette Tape
and Rewind
Recording
\
peeving
/
Cassette
|
Recorder
Operation
Programming
Console
Operation
Verification
Operation
‘thi
Sees
Recording
Playing
ES Operation Operation
Write-in
RAM
Read-out
|
ROM 7 TAPE l TAPE > RAM
fa 3

Omron SYSMAC C Series Specifications

General

Brand	Omron
Model	SYSMAC C Series
Category	Controller
Language	English