Omron V600 Series User Manual

36
Section 2 Wiring
RFID System
Operation Manual
Section 2
Installation and Wiring
■ Installing the USB Driver
When using a USB cable to connect the ID Controller to the host device for the first time, the USB
Driver must be installed on the host device.
■
Installing the USB Driver in the Computer
The V600-CA5D01 and V600-CA5D02 supports Windows 2000 and Window XP operating systems.
Install the driver in the host device following the procedure corresponding to the OS being used.
Operation on other OS is not supported.
Operation on other OS is not supported.
Windows 2000
1. Turn ON the power to the personal computer and start Windows 2000.
2. Connect the ID Controller to the personal computer using the USB interface.
Refer to USB Port for more information.
p.34
The following window will be displayed when the ID Controller is connected.
3. When the following window is displayed, click the Next Button.

Omron V600 Series Specifications

General

Operating Frequency	13.56 MHz
Supported Standards	ISO 15693, ISO 18000-3
Read Range	Up to 70 mm (depending on tag and environment)
Power Supply	24 VDC ±10%
Operating Temperature	-10 to 55°C (with no icing or condensation)
Humidity	35% to 85% (non-condensing)
Communication Interface	RS-232C