Omron V600 Series User Manual

81
RFID System
Operation Manual
Section 5 Command Format
Section 5
Communications
■ Host Device Commands
Host Device Commands are used to control the ID Controller.
FCS Calculation Example
■ Calculating the FCS for a 5-byte Read from Address 0010H
Command code Name Description
More informa-
tion
TS TEST Used to check communications between the ID Controller and the host device.
Returns the test message sent from the host device without any changes.
p.125
CC CONTROLLER CON-
TROL
Used to manipulate user I/O.
p.126
CF ERROR READ Reads the error log. p.128
TR COMMUNICATIONS
CONDITIONS SET-
TING
Sets conditions for serial communications.
p.130
SP PARAMETER SET-
TING
Sets, reads, and initializes ID Controller parameters.
p.132
0100
0011
0011
0101
0100
0100
0011
0011
0011
0011
0011
0011
0011
0000
0000
0010
0010
0100
1000
0001
0000
0000
0001
0000
0000
0101
XOR
XOR
XOR
XOR
XOR
XOR
@
0
2
R
D
H
1
0
0
1
0
0
5
0010 1001
40
30
32
52
44
48
31
30
30
31
30
30
35
XOR
XOR
XOR
XOR
XOR
XOR
00
01
H
10
29
5
FCS
*CR
RD
2
@ 0
Controller No.
Command
code
Data
Terminator
FCS calculation range
FCS data: 29
Original Data
ASCII Data
(Hexadecimal)
Binary
Data
Data
converted
to ASCII
Data
converted
to binary
Exclusive ORs taken
Data converted to
hexadecimal

Omron V600 Series Specifications

General

Operating Frequency	13.56 MHz
Supported Standards	ISO 15693, ISO 18000-3
Read Range	Up to 70 mm (depending on tag and environment)
Power Supply	24 VDC ±10%
Operating Temperature	-10 to 55°C (with no icing or condensation)
Humidity	35% to 85% (non-condensing)
Communication Interface	RS-232C