parameters for the treatment. Pressing this button during the treatment will
start the retuning algorithm, to find a new tuner position.
Pressing the Start-button for a longer time changes the Modulation-mode.
(If it was off, then it will turn on, and if it was on, it will turn off.) Modulation
does not have any effect on temperature.
Stop: With this button you can pause or stop the treatment. If you only
pause the treatment, you can continue it later at where you left it, no
parameters will be changed. But if you stop it, then all the parameters will
be reset to their default value. The actual information will be stored only on
the computer (if any).
Press for a longer period to stop the RF power (treatment).
Pause: Press only for a short time to pause the treatment. RF power is
stopped.
Motor 1 clockwise: Rotate the first tuning motor clockwise. You should use
this only if you are an advanced user.
Motor 1 anticlockwise: Rotate the first tuning motor anticlockwise. You
should use this only if you are an advanced user.
Motor 2 clockwise: Rotate the second tuning motor clockwise. You should
use this only if you are an advanced user.
Motor 2 anticlockwise: Rotate the second tuning motor anticlockwise. You
should use this only if you are an advanced user.
Automatic/Manual selection
Automatic: Press for a short period of time to set automatic mode. In
automatic mode all limits are checked, and power is managed by the
attached computer. In automatic mode you can press this button shortly
when you reach 46°C-47°C on the E.C.M temperature and the alarm sound
will disappear. You can continue the treatment carefully.
• Manual: Press it for a long period of time to set manual mode. In manual
mode a lot of things are not controlled by the microcontroller.
Mute: Mute the device with this button if there is an alarm for high temperature
and temperature display flashes.
Power / Time selection: To select the function of the up/down buttons. This will
change from time to power or from power to time settings. The actual Mode is
indicated by a yellow Light at the Up/Down- Buttons
Up (+): You can change the actual time limit or power setting upward with this
button. The one you change depends on the power/time selection button.
Down (-): You can change the current time limit or power setting downward
with this button. The one you change depends on the power/time selection
button.
To Next Page
Loading...