Appendix 6 - Treatment in 9 steps
The following points contain the steps of a typical treatment. It is suggested to
keep a copy of this page near the device.
1. Choose the proper electrode and disinfect it.
2. Fix the electrode on the holding arm and connect the water tubes.
3. Connect the electrode cable to the device and fix the cable on the
holding arm on every possible point.
4. Let the self-test run. The self-test takes about 2 minutes.
5. Switch on the device by the Main switch on the front of the device
6. Lay the patient on the waterbed and place the electrode as horizontal as
possible on the patient on the identified treatment area.
7. Set the treatment parameters by the Select, Up and Down buttons
8. Start the treatment with the Start button
9. Let the treatment run until the set time runs out. The device signs the end
of the treatment by a sound signal. After pushing the Stop button the
device makes a self-test automatically, after that you can begin the next
treatment.
To Next Page
Loading...