Doing a treatment
• The patient lies down in the bed in a comfortable position. Note that the
patient has to keep this position during the whole treatment process, so
please take care of the proper arrangement. Place the applicator on
them on the area intended to be treated.
Important: Please remove all the metallic things from the treated patient.
• You have to set the desired treatment parameters, such as treatment
time, treatment power and modulation. This can be adjusted by the
attached computer, or by the switches on the device. The adjusted
parameter can be chosen by the Select button and can be set by the
Up and Down buttons. The set time is indicated continuously, but the set
power is indicated during the setting process, normally the actual
outgoing power is indicated. The following picture is taken during the
treatment time setting. Note the LED under the Up/Down buttons, which
indicates the currently adjusted parameter.
To Next Page
Loading...