ONE Technologies
- 13 -
Restart your computer after installing the software. Connect your
new ONE drive with the power cord to a suitable current source
(110-260 V) and switch it on. After your computer has finished its
restart connect the device to the FireWire port of your Mac with the
included FireWire cable.
After some seconds the drive is recognized by the system and can
be used.
If you bought a DVD Multirecorder please install the DVD-RAM
driver and tools included on the ONE_ToolsCD. Macintosh users
need no additional drivers if using OS 9.2.1 or higher.
To record DVDs or CDs (depending on the drive you bought),
additional recording software is needed.
USB 2.0
At this time high-speed USB 2.0 AluDRIVES are NOT released for
use with Apple Macintosh Computers! There is no USB 2.0 support
for AluDRIVES under Mac OS. Although you can use them as
“normal” USB 1.1 devices in combination with the Mac operating
systems with a limitation of USB 1.1 speed (CD recording at max. 4x
speed)! That means that you can record CDs at 4x speed, but
unfortunately the data transfer rate is too slow for recording DVDs.
Installation:
First start your Macintosh computer without having the drive
connected. Insert the ONE_ToolsCD and install the USB drivers
provided on the CD depending on your OS (OS 9.x/OSX prior to
10.3. OSX 10.3 and higher has built in USB 2.0 support – no
additional drivers are needed!). If you have installed the drivers, you
must restart your computer. After the operating system is loaded
completely again, connect your drive with the included power supply
to a suitable current source (110-260V), switch it on and connect it
with the USB cable to the USB port of your computer. After a few
To Next Page
Loading...