ONE Technologies
- 8 -
Installation:
First start your Macintosh computer without having the drive
connected. Insert the ONE_ToolsCD and install the USB drivers
provided on the CD depending on your OS (OS 9.x/OSX 10.1 or
higher – OSX 10.3 and higher already has a built in USB 2.0
support. In this case you must not install additional drivers!). If you
have installed the drivers, you must restart your computer. After the
operating system is loaded completely again, connect your drive
with the included power supply to a suitable current source (110-
260V), switch it on and connect it with the USB cable to the USB
port of your computer. After a few seconds the drive is recognized
by the system. At this time you can use the recorder only as CD-
ROM drive. For using it as a CD recorder you have to install optional
CD recorder software. ONE Technologies CD/R/RW drives are
tested with TOAST by Roxio software (www.roxio.com). Contact
your local dealer to obtain a special priced OEM bundle version!
2.3 Installation on a Windows System
FireWire:
Connect your drive to a suitable current source (110-260V). Switch
on the device and connect it via the included FireWire cable to your
computer. Start up the computer now. Windows will recognize and
install the recorder, additional drivers are not needed, although in
some cases, Windows will ask for the Windows installation CD –
To Next Page
Loading...