ONE Technologies
- 23 -
Installation:
5.1 Installing the hardware
Windows 98SE and Windows Millenium:
Start your personal computer without having the drive connected.
After the operation system has been loaded completely, install the
USB drivers provided on the ONE_ToolsCD (follow the steps in the
autostart menu of the CD). Restart your computer. Connect the
drive to a suitable power source and switch it on. After this, connect
the drive to the USB 2.0 port of your computer. Windows will now
automatically detect and install the AluDISC backup. Even if the disk
is now installed (it will be shown in the device manager as hard
drive), you will have to create one ore more partitions and to format
them before the device can be used. Until this configuration is done,
you will not see it under “my computer” or the “windows explorer”.
Use the program “fdisk” (part of windows) or the “shining utilities”
(ONE_ToolsCD) to format the disk. Please refer to the ONE
Technologies User Manual on the ONE_ToolsCD if you are unsure
using these programs. In the Manual you will find a step by step
instruction for both applications.
Windows 2000* and Windows XP**:
Start your personal computer without having the drive connected.
Make sure that you have the latest service packs installed. If not
download them from www.microsoft.com. If your system is up to
To Next Page
Loading...