ONE Technologies
- 46 -
Before installing your new drive make sure, that the USB 2.0 card is
installed correctly and working properly!
First start your Macintosh computer without having the drive
connected. Insert the ONE_ToolsCD and install the USB drivers
provided on the CD depending on your OS (OS 9.x/OSX 10.1 and
higher. OSX 10.3 and higher does not need additional drivers. It has
built in USB 2.0 support! ). If you have installed the drivers, you
must restart your computer. After the operating system is loaded
completely again, connect your drive with the included power supply
to a suitable current source (110-260V), switch it on and connect it
with the USB cable to the USB port of your computer. After some
seconds the drive is recognized by the system. The system will ask
you to initialize the drive. Do so by choosing the desired type
(HFS/HFS+). After initialization you can use it like any other hard
disk too.
6.3 Installation on a Windows System
Windows FireWire:
Connect the device with the FireWire cable to a free FireWire port
on your computer. Now switch on your PC. Windows will recognize
and install your hard disk automatically. Additional drivers are not
needed, but maybe Windows will ask for the Windows installation
CD to complete the installation. Restart your computer. After the
system has been loaded completely again, your hard disk is
installed. Now the device manager shows the new drive. Like any
hard drive (IDE, SCSI, internal or external) it must be configured
To Next Page
Loading...