ONE Technologies
- 24 -
date, connect the drive to a suitable power source and switch it on.
Afterwards connect it to the USB 2.0 port of your computer.
Windows will automatically detect and install the drive.
Like any other hard disk too, the drive has to be set up by creating
one or more partitions and by formatting them afterwards. Before
doing so, you will not see the drive under “my computer” or in the
“windows explorer”. Please use the program “disk management”
(part of windows). If you are unsure using the program, please refer
to the ONE Technologies User Manual on the ONE_ToolsCD where
you can find a step by step instruction!
*Windows 2000 without service pack needs additional USB 2.0
drivers from ONE_ToolsCD (see installation under Windows
98SE/Me)
** Windows XP needs Service Pack 1 or higher or at least the USB
2.0 update from www.microsoft.com to support USB 2.0 drives!
5.2 Installing the software
To be able to create backups by using the front buttons of the drive,
you have to install the bundled software as well.
Insert the ONE_ToolsCD in your computers CD-Rom drive and
follow the autostart menu to “Alu DISC Backup Software”. Install the
software by following the setup wizard. After setup has completed,
restart your system. Do so even if the system does not ask you to!
After the reboot, the button drivers are loaded and the AluDISK
backup is ready for use!
To Next Page
Loading...