ONE Technologies
- 72 -
13.2 Quick installation guide „Shining Utilities“
ONE_ToolsCD/Extras/Utility Suite
The use of this software makes it necessary that the drive is already
installed properly to your system. That means that the drive has to
be connected and drivers have to be installed like explained in the
drive specific chapters above. For using your drive, it has to be
partitioned and formatted.
This guide explains the use of „Shining Utilities“:
Install the software from the ONE_ToolsCD. After installing the
software, start it by double-clicking on the Shining Utilities icon.
Choose “Hard Disk Setup” from the main menu. If you are using
Windows 2000, NT or XP the software directs you to the disk
management console of windows.
Under Windows 95,98,98SE and ME it is an alternative to FDISK.
IMPORTANT NOTICE: The following description is an example.
Your system can have different drive letters and names. Please
always ensure that you choose the correct hard disk while following
the described steps. Creating/changing partitions or formatting a
drive deletes all stored data on the disk!
Windows 95,98,98SE and ME users continue like this:
Install the software and start it. The following menu will be shown:
To Next Page
Loading...