ONE Technologies
- 18 -
First start your Macintosh computer without having the drive
connected. Insert the ONE_ToolsCD and install the USB drivers
provided on the CD depending on your OS (OS 9.x/OSX 10.1 and
higher. OSX 10.3 and higher does not need additional drivers. It has
built in USB 2.0 support! ). If you have installed the drivers, you
must restart your computer. After the operating system is loaded
completely again, connect your drive with the included power supply
to a suitable current source (110-260V), switch it on and connect it
with the USB cable to the USB port of your computer. After some
seconds the drive is recognized by the system. The system will ask
you to initialize the drive. Do so by choosing the desired type (
HFS/HFS+). After initialization you can use it like any other hard disk
too.
4.3 Installation on a Windows System
FireWire
Connect your drive with the included power cable to a suitable
current source (110-260 V) and switch it on. Connect the device with
the FireWire cable to a free FireWire port on your computer. Now
switch on your PC. Windows will recognize and install your hard disk
automatically. Additional drivers are not needed, but maybe
Windows will ask for the Windows installation CD to complete the
installation. Restart your computer. After the system has been
loaded completely again, your hard disk is installed. Now the device
manager shows the new drive. Like any hard drive (IDE, SCSI,
internal or external) it must be configured before you can use it! As
you may recognize, the drive is shown in the device manager, but
To Next Page
Loading...