ONE Technologies
- 19 -
not in the explorer or in “my computer”. To get it to mount, you have
to create one or more partitions on the disk and format them
afterwards. Under Windows 98SE und ME you can use the program
„FDISK“ , under Windows 2000 or XP use the “disk management”
(Computer Management). As an alternative to „FDISK“ you can also
use the “Shining Utilities” from the ONE_ToolsCD, which allows
configuring of your disk with a graphical interface. Detailed
explanations can be found in the chapter „Hard Disk Tools“.
Please pay attention to the chapter „Common FireWire Hints“. If you
have difficulties while installing or using the drive please refer to
chapter „Troubleshooting & Support“.
USB 2.0
High-speed USB 2.0 is ONLY supported by Windows 98SE, ME, XP
(XP needs Service Pack 1 *) and 2000. All HighFly USB 2.0
devices are downwards compatible. That means that you can use
them also under older systems, but only as USB 1.1 devices with
USB 1.1 speed! Please remember: Windows 95a and NT do NOT
support USB at all!
First start your computer without having the drive connected.Under
Windows 98SE, Windows Me and Windows 2000 without Service
Pack install the USB drivers from the ONE_ToolsCD. If you are
using Windows 2000 or XP with the latest Service Packs installed
no additional drivers are required. Restart your system after driver
installation. After the operating system is loaded completely again,
connect your drive with the included power supply to a suitable
current source (110-260V), switch it on and connect it with the USB
cable to the USB port of your computer. After some seconds the
drive is recognized by the system and will be installed automatically.
To Next Page
Loading...