ONE Technologies
- 7 -
2.2 Installation on a Macintosh System
FireWire:
Installation to a Macintosh:
Switch on your computer (do not connect the drive yet!). After the
operating system has been loaded completely, insert the
ONE_ToolsCD and install the drivers for ONE FireWire drives.
Restart your computer after installing the software. Connect your
new ONE drive with the power cord to a suitable current source
(110-260 V) and switch it on. After your computer has finished its
restart connect the device to the FireWire port of your Mac with the
included FireWire cable.
After a few seconds the drive is recognized by the system and can
be used. Please notice that the CD-R/RW drive can only be used as
a CD-ROM drive at this time. To be able to create own CD-Rs or
CD-RW media you have to use additional software. ONE
Technologies recommends the use of „TOAST“ by Roxio Software
(www.roxio.com).
If you have any difficulties while installing or using the drive, refer to
the chapter „Troubleshooting & Support“.
USB 2.0:
There is no USB 2.0 support for AluDRIVES under Mac OS.
Although you can use them as “normal” USB 1.1 devices in
combination with the Mac operating systems with a limitation of USB
1.1 speed (CD recording at max. 4x speed)!
To Next Page
Loading...