ONE Technologies
- 9 -
please ensure that you have it handy. After the operating system
has been loaded completely your drive is installed; you can see it in
the device manager under CD-ROM drives. That is all you can use it
for at this time: a CD-ROM. For using it as a CD recorder, you have
to install separate CD recording software (e.g. Nero-Burning ROM
by Ahead Software, www.nero.com). A 30-day trial version is
provided on the ONE_ToolsCD.
Please also refer to the chapter „common hints to FireWire“ and the
Appendix „CD Glossary“. If you have difficulties while installing or
using your drive refer to the chapter „troubleshooting & support“.
USB 2.0:
High-speed USB 2.0 is ONLY supported by Windows 98SE, ME, XP
(XP needs Service Pack 1 *) and 2000. All HighFly USB 2.0
devices are downwards compatible. That means that you can use
them also under older systems, but only as USB 1.1 devices with
USB 1.1 speed! Please remember: Windows 95a and NT do NOT
support USB at all!
First start your computer without having the drive connected.Under
Windows 98SE, Windows Me and Windows 2000 without Service
Pack install the USB drivers from the ONE_ToolsCD. If you are
using Windows 2000 or XP with the latest Service Packs installed
no additional drivers are required. Restart your system after driver
installation. After the operating system is loaded completely again,
connect your drive with the included power supply to a suitable
current source (110-260V), switch it on and connect it with the USB
cable to the USB port of your computer. After some seconds the
drive is recognized by the system. At this point you can use the
recorder only as CD-ROM drive. For using it as a CD recorder you
have to install optional CD recorder software. ONE Technologies
To Next Page
Loading...