ONE Technologies
- 15 -
USB 1.1 speed! Please remember: Windows 95a and NT do NOT
support USB at all!
First start your computer without having the drive connected.Under
Windows 98SE, Windows Me and Windows 2000 without Service
Pack install the USB drivers from the ONE_ToolsCD. If you are
using Windows 2000 or XP with the latest Service Packs installed
no additional drivers are required. Restart your system after driver
installation. After the operating system is loaded completely again,
connect your drive with the included power supply to a suitable
current source (110-260V), switch it on and connect it with the USB
cable to the USB port of your computer. After some seconds the
drive is recognized by the system. At this time you can use the
recorder only as CD-ROM drive. For using it as a DVD recorder you
have to install optional CD recorder software. ONE Technologies
DVD drives are tested with Nero burning ROM by Ahead software
(www.nero.com). Contact your local dealer to obtain a special priced
OEM bundle version!
If you bought a DVD Multirecorder please install the DVD-RAM
driver and tools included on the ONE_ToolsCD.
To record DVDs or CDs (depending on the drive you bought),
additional recording software is needed.
ONE Technologies recommends using „NERO Burning Rom“ by
Ahead Software (www.nero.com).Only additional recording software
lets your AluWRITER come a recorder!
To create your own DVDs or CDs, please refer to the manuals of the
recording software products!
If you have difficulties while installing or using your drive refer to the
chapter „Troubleshooting und Support“!
To Next Page
Loading...