ONE Technologies
- 48 -
additional USB 2.0 PCI adapter card. Same situation here: Only
Windows 98SE, ME, XP (with update/Service Pack) and 2000 are
supporting USB 2.0 cards with full speed. Under older systems it
only can be used as USB 1.1 card!
Before installing your new drive make sure that the USB 2.0 card is
installed correctly and working properly!
First start your computer without having the drive connected. After
the operating system is loaded completely, connect your drive to the
USB port of your computer. After some seconds the drive is
recognized by the system and the hard disk will now be shown in
the device manager (not under „my computer“ or in the „windows
explorer“). Like every new installed hard disk, it has to be
configured. Therefore you have to create one or more partitions and
format them afterwards. If you are using Windows 98SE or ME you
can use the program „FDISK“, under Windows 2000 and XP you
have to use the „Computer Management“.). As an alternative to
„FDISK“ you can also use the “Shining Utilities” from the
ONE_ToolsCD, which allows configuring your disk with a graphical
interface. Detailed explanations can be found in the chapter „Hard
Disk Tools“.
After restarting the system afterwards, your hard disk is installed
and can be used.
Please pay attention to the chapter „Common USB Hints“!
If you have any problems while installing or using your ONE
Technologies drive please refer to the chapter „Troubleshooting &
Support“.
To Next Page
Loading...