CE/EU Declaration of incorporation (Original)
According to European Machinery Directive 2006/42/EC annex II 1.B.
The manufacturer:
OnRobot A/S
Teglværskvej 47H
DK-5220, Odense SØ
DENMARK
declares that the product:
Type: Industrial Robot Gripper
Model: VG10 Vacuum Gripper
Generation: G1
Serial: PR10.8018.00000 - PR10.8018.99999
may not be put into service before the machinery in which it will be incorporated is
declared in conformity with the provisions of Directive 2006/42/EC, including
amendments, and with the regulations transposing it into national law.
The product is prepared for compliance with all essential requirements of Directive
2006/42/EC under the correct incorporation conditions, see instructions and guidance
in this manual. Compliance with all essential requirements of Directive 2006/42/EC
relies on the specific robot installation and the final risk assessment.
Technical documentation is compiled according to Directive 2006/42/EC annex VII part
B and available in electronic form to national authorities upon legitimate request.
Undersigned is based on the manufacturer address and authorized to compile this
documentation.
Additionally, the product declares in conformity with the following directives,
according to which the product is CE marked:
2014/30/EU — Electromagnetic Compatibility Directive (EMC)
2011/65/EU — Restriction of the use of certain hazardous substances
(RoHS)
Relevant essential health and safety requirements of the following EU directives are
also applied:
2014/35/EU — Low Voltage Directive (LVD)
2012/19/EU — Waste of Electrical and Electronic Equipment (WEEE)
A list of applied harmonized standards, including associated specifications, is provided
in this manual.
Odense, April 1
th
, 2018 Corporate Management
To Next Page
Loading...
