Chapter 6: Alerts, Auto-Response & Logging
110
2. Enter the IP or DNS Host Address of the host. If this is a DNS address, it must be resolvable by the
gateway.
3. Select which Services are to be used in accessing the new host. A range of service options are
pre-configured in the default SDT Connector client (RDP, VNC, HTTP, HTTPS, Dell RAC, VMware
etc).
If you wish to add new services, proceed to the next section (Adding a new service) and return
here.
4. Optionally, enter a Descriptive Name for the host, to display instead of the IP or DNS address, and
Notes or a Description of this host.
5. Click OK
5.2.5 Manually adding new services to the new hosts
To extend the range of services that can be used when accessing hosts with SDT Connector:
1. Select Edit > Preferences and click the Services tab. Click Add
2. Enter a Service Name and click Add
3. Under the General tab, enter the TCP Port that this service runs on (e.g. 80 for HTTP). Optionally,
select the client to use to access the local endpoint of the redirection
To Next Page
Loading...
Need help?
General
