Opengear CM7100 User Manual

8.4 Adding Opengear custom attributes
You can use an Opengear Vendor Specific Attribute when specifying group mappings via RADIUS.
Opengear has an IANA enterprise number of 25049 with our own vendor specific attributes under that
enterprise number.
Create a file called /etc/freeradius/$VERSION/dictionary.opengear containing:
VENDOR Opengear 25049
BEGIN-VENDOR Opengear
ATTRIBUTE Opengear-MappedGroups 1 string
END-VENDOR Opengear
Edit /etc/freeradius/$VERSION/dictionary to include that file:
$INCLUDE dictionary.opengear
Add the following “update reply {}” block to /etc/freeradius/$VERSION/sites-enabled/default inside the
“authorize {}” section at the end. (
NOTE the ‘&' before 'Opengear’ should not be there in some older versions of freeradius eg. 2.1.12
authorize {
...
...
...
update reply {
&Opengear-MappedGroups = "group1,group2,group3"
}
}
Check if configuration is correct and restart the server
sudo freeradius –CX
sudo service freeradius restart

Opengear CM7100 Specifications

General

Brand	Opengear
Model	CM7100
Category	Server
Language	English