23
Model 72 User Manual - OPEX Corporation
- RATE - Rate of envelopes processed per hour.
- BURST - Best six minutes of processing during the current job.
11 Push the Cycle button to send the first envelope through the Model 72.
12 When the envelope reaches the extractor, it will stop. Be sure to remove all
the contents from the envelope. This is especially important for the first
envelope, because the Model 72 will use this as the gauge for determining
the thickness of an empty envelope for all future envelopes.
13 Press the Cycle button to send the empty envelope to the verifier. The next
envelope will arrive at the extractor.
14 Once the first envelope is extracted and the Cycle button is pressed,
machine cycling is automatic when in the preferred Differential or Content
modes. You should never run the Model 72 in Time Out mode (used for
technical troubleshooting), Removal mode is a last resort.
15 If an envelope stops at the verifier and the red indicator lamp is illuminated,
you must remove the entire envelope before continuing. Inspect the
removed envelope for any missed content.
16 While running the machine, you should watch trash levels and chip
“haystacking” to prevent backups that might jam the cutters and create a
service call.
Adjust LCD Contrast
The LCD contrast level can be adjusted for optimal viewing.
1 Press the Stop button on the keypad so that the LCD is in the off state.
2 Press the Left button. The “Adjust LCD Contrast” screen appears
(Figure 17).
Figure 17: Adjust LCD Contrast screen
PUSHING THE ENVELOPE...
THROUGH THE 21ST CENTURY!
OPEX CORPORATION
Use UP or DOWN to adjust intensity: 105
To Next Page
Loading...