24
Model 72 User Manual - OPEX Corporation
3 Use the Up or Down buttons to darken or lighten the display as desired. A
numerical value in the lower right corner of the display will indicate the
display setting. The value can range from 0 (lightest) to 255 (darkest).
4 Once the contrast level is set for optimal viewing, press Cancel to exit the
“Adjust LCD Contrast” screen. The login screen is then displayed.
The LCD contrast can also be adjusted while the LCD is in the off state by
pressing the Up and Down buttons without pressing the Left button first. In this
case, the LCD contrast level will change, but the LCD Contrast screen will not
appear.
Setting and Viewing Operator Passwords
The Operator has the ability to set and reset their password. However, the
operator will need to enter his/her current password before the password can
be reset. In cases where the current password is blank, the user will not be
prompted to enter their current password before entering a new password. The
supervisor also has the ability to view and change operator passwords.
To change a password
1 After logging in, select PASSWORD from the Main Menu screen to change
the currently selected operator’s password.
Figure 18: Main Menu screen
The CHECK PASSWORD screen (Figure 19) will be displayed to remind the
operator that leaving the password blank will disable the password feature.
Wednesday, March 3, 2010 10:34 A.M.
OPERATOR: PAT
JOB: NEW
SELECT JOB PASSWORD STATISTICS
To Next Page
Loading...