Opex 72 - Page 58

58
Model 72 User Manual - OPEX Corporation
36
FEED TRAY
PIECE
DETECTION
TIMEOUT
This jam is called when both the Upper Feed and
Lower Feed sensors in the feed tray are found to
be unblocked upon the expiration of the timeout
period.
37
FEED TRAY
PIECE JUSTIFI-
CATION
TIMEOUT
This jam is called when only the Lower Feed
sensor in the feed tray is found to be unblocked
upon the expiration of the timeout period.
38
FEED TRAY
DETECTED
MORE THAN
ONE PIECE
This jam is called when more than one envelope is
detected to be in the feed tray.
Clear the feed tray area.
39
COMM LAPSE
DETECTED ON
CONTROLLER
This jam is called when there is a communication
error, possibly caused by a loose connector or
defective cable.
Place a service call if the problem persists.
40
INVALID
MACHINE STATE
DETECTED
This jam is called when the upper level Smart
Driver software receives an invalid state from the
controller.
Place a service call if the problem persists.
41 COMM FAULT
This jam is called when the controller side is
having difficulties sending messages to the Smart
Driver board.
Place a service call if the problem persists.
Table 1: Error messages (continued)
Error Number &
Message
Description