57
Model 72 User Manual - OPEX Corporation
29 OUTPUT FAULT
This jam is called if the output board detects any
faults at its DC outputs (in other words, a DC motor
is being driven with less than the required voltage,
or it is drawing more than the maximum current
allowed by the output board).
Place a service call.
30
FEED EXIT
SENSOR
BLOCKED TOO
LONG
This is called when the time it takes an envelope
that is traveling past the Feed Exit sensor is
greater than the time it would take a 17.25 inch
envelope to pass the sensor. This jam is also
called if the transport motor cannot always pull a
piece that is being held by the feeder belts. In
these cases, the motor does not move, even
though software is attempting to move it. A hard-
coded time value of 5 seconds is being used.
31
PIECE LENGTH
FAILURE -
CHECK FEED
TRAY
This is called when the time it takes an envelope
that is traveling past the Feed Exit sensor is less
than the time it would take a 5 inch envelope to
pass the sensor.
32
COMM LAPSE
DETECTED ON
SMART DRIVER
This jam is called when the output board has not
detected any communication from the control
board.
Place a service call.
33
PLEASE CLEAR
THE SIDE
CUTTER NIP
This jam is called when the Side Cut Justifier
sensor is blocked during the start of machine run.
Clear the feed tray area.
34
PLEASE CLEAR
UPPER
JUSTIFIER
SENSOR
This jam is called when the Upper Justifier sensor
is blocked during the start of machine run.
Clear the feed tray area.
35
PLEASE CLEAR
LOWER
JUSTIFIER
SENSOR
This jam is called when the Lower Justifier sensor
is blocked during the start of machine run.
Clear the feed tray area.
Table 1: Error messages (continued)
Error Number &
Message
Description
To Next Page
Loading...