Opex 72 - Page 56

56
Model 72 User Manual - OPEX Corporation
23
TRANSPORT
HEIGHT ADJUST
TIMEOUT
During automatic position setting, the transport
must first go to the full up position, then move
down the necessary amount. There is a defined
nominal amount of time that it takes to lower the
transport from full up to full down position. The
transport must be able to find the full up position
within 120% of the timeout time, or this error
message appears. In other words, the timeout time
is 20% longer than the normal time. Causes for this
jam are 1) timing error or 2) malfunctioning
Transport Home sensor.
Place a service call.
24
PLEASE EMPTY
THE SIDE CUT
TRASH
This jam is called if the Chip Backup sensor,
located in the side cutter trash chute, is blocked
and the amount of envelopes that have processed
during that time equals or exceeds a predefined
amount. Empty the trash.
25
INTERLOCK-1 IS
OPEN
This jam is called if the hinged cover located just
above the feeder retard wheel is opened before or
during a machine run.
Close the cover.
26
INTERLOCK-2 IS
OPEN
This jam is called if the feeder cover located to the
right of the feed tray is removed or opened before
or during a machine run.
Close the cover.
27
INTERLOCK-3 IS
OPEN
This jam is called if the top cutter cover is opened
before or during a machine run.
Close the cover.
28
INTERLOCK-4 IS
OPEN
This jam is not currently used.
Table 1: Error messages (continued)
Error Number &
Message
Description