Opex 72 - Page 55

55
Model 72 User Manual - OPEX Corporation
20
PLEASE CHECK
THE FEED TRAY
As the feeder completes a cycle, the feed tray
sensor is monitored. If this sensor becomes
blocked, an envelope is assumed to have arrived,
and it uses a defined amount of time to settle itself.
Immediately after this time, the feed tray sensor is
rechecked. If it is unblocked, then the envelope
has been lost. This can be caused by a skewed
envelope in the feeder. It can also be caused by
the fence stuck in the down position, allowing the
fed envelope to slide immediately down into the
shuttle.
Clear any envelopes in the feed tray.
21
THE CLEAT IS
STUCK
The cleat motor must be able to complete a full
revolution within a defined amount of time.
Otherwise, this error message appears. This could
be caused by something preventing the belt from
moving, or by a malfunctioning cleat home sensor.
Check and clear any stuck objects in the feed tray.
22
THE SHUTTLE IS
STUCK
The shuttle must be able to make it home (from
any position) within a defined amount of time,
otherwise this error message appears. This could
be caused by a stuck shuttle, incorrect wiring to the
shuttle motor, or by a malfunctioning shuttle home
sensor.
Check and clear any stuck objects in the feed tray.
Table 1: Error messages (continued)
Error Number &
Message
Description