54
Model 72 User Manual - OPEX Corporation
15
POSSIBLE
DROPPED ENV. -
- CHECK TRASH!
This jam is intended to prevent envelopes from
falling into the trash prematurely. After the trail
edge of an envelope passes the Verifier Entry
sensor, the belt must stop within a defined amount
of time, or it could fall into the trash. After the
verifier section is stopped and an envelope is not
detected at the Discard sensor, the transport is
stopped and the “POSSIBLE DROPPED ENV. --
CHECK TRASH” jam is called.
Check and resume operation.
16
PLEASE CLEAR
THE VERIFIER
AREA
This jam is called only during the diagnostic belt
speed test when the envelope takes too long to
clear the Verifier Entry sensor.
17
SOFTWARE
ERROR
Possible error in the software. If this should
appear, place a service call.
18
CANNOT
JUSTIFY MAIL
CONVEYOR
If the mail conveyor cannot press the mail against
the stop within 30 seconds of starting, then this
message appears. This could be caused by a
faulty conveyor position sensor, a malfunctioning
conveyor motor, or by the mail pusher which is not
resting on the conveyor.
Check that the mail is set up correctly on the
conveyor and that the pusher is in the correct
position. If you still get this error, place a service
call.
19
REMOVE
ENVELOPE -
CHECK FOR
CONTENTS
Not currently used.
Table 1: Error messages (continued)
Error Number &
Message
Description
To Next Page
Loading...