Opex 72 - Page 53

53
Model 72 User Manual - OPEX Corporation
10
PLEASE CLEAR
THE EXTRACT
ENTRY
If the trail edge of the envelope is not seen within a
defined amount of time, then the envelope must be
hung up, so a “PLEASE CLEAR THE EXTRACT
ENTRY” jam is called. Clear any envelopes.
11
MISSING
ENVELOPE AT
EXTRACT
Once the envelope has stopped in the extract and
the cups have opened, the extract sensor must be
blocked (by at least two sheets of paper). If this
sensor is not blocked, then the envelope probably
jammed between the top cutter and extractor.
Thus, a “MISSING ENVELOPE AT EXTRACT” jam
is called. Clear any envelopes.
12
PLEASE CLEAR
THE EXTRACT
This is not currently used.
13
THE EXTRACT
CUPS ARE
STUCK
The extract cups must be able to complete a full
cycle within a defined amount of time, otherwise
this error message is displayed. This jam could be
caused by a faulty or disconnected motor, a stuck
mechanism, or by a faulty extract open sensor.
Place a service call.
14
EARLY
REMOVAL OF
CONTENT AT
EXTRACT
Once the envelope has stopped in the extract and
the cups have opened, the extract sensor must be
blocked (by at least two sheets of paper). If the
extract sensor is not blocked at the time the
envelope is to be scanned for its contents, then the
envelope probably has been removed early. Thus,
an “EARLY REMOVAL OF CONTENT AT
EXTRACT” jam is called.
Check and resume operation.
Table 1: Error messages (continued)
Error Number &
Message
Description