2 Operating the System
August 2010 AS-Series Operator Manual 2-11
Run screen buttons
Press Go to start the scanner.
The
Page Type buttons allow the operator to designate the page type of the next document.
The
Page Type buttons will only be available if they have been activated in the general page
type parameters. See “Assigning a page type” on page 2-21 for more information.
Rotate the image of the selected document. Use the three buttons to rotate the image
front-to-back, top-to-bottom, or 90°. These buttons will only be available if activated as
described in “General page type parameters” on page A-2.
Adjust the settings in the Capture Parameters window to enhance the quality of the output
images. See “Adjusting image quality” on page 2-23.
Press a
Rescan button to replace a previously scanned image with a new one. See
“Rescanning documents” on page 2-23 for more information.
Delete a document from the batch. This is only available when the machine is stopped. See
“Deleting documents from the batch” on page 2-24.
Void the selected document or transaction. The Void buttons are only available if activated in
the batch parameters as described on page A-40. See “Voiding documents and transactions”
on page 2-25 for more information.
End the current
Transaction. This button will only be available if it has been activated in the
batch parameters. See page A-32 for more information.
Start a
New Batch. This button will only be available if it has been activated in the batch
parameters. See page A-40 for more information.
Press the Action button to access the Rescan, New Batch, and Void buttons. The Action
button only appears if two or more of these buttons (
Rescan, New Batch, Void) are enabled.
Stop the machine. This does not end the current batch or transaction.
Close the current batch.
Exit the current job and close the Run screen.
To Next Page
Loading...
