A Statistics
A-6 AS3690 Operator Manual August 2010
Performance Details statistics
The following table list the terms that appear in the Performance Details section of
the statistics report.
NOTE: All times noted in the formulas in this table are in seconds. For example, if the
Active Job Time appears as “00:01:49” then that means one minute (60
seconds) plus 49 seconds, or 109 seconds.
The Rejects section lists the reasons for the rejected documents and how many
documents were rejected for each reason.
TABLE 4: Performance Details terms
Term Definition
Active Job Time
Time the AS-Series was either actively running or was halted due to a jam.
Active Job Time is broken down by:
•Run Time
• Jam Time
Run Time
Total run processing time.
Jam Time
Total time the AS-Series was halted for a jam.
Idle Time
Time the Operator was in the Run Job window, but the AS-Series was not
processing pieces.
TABLE 5: Reasons for rejected items
Length Too Long
Results when an image is longer than the maximum allowable image size
of the system or when outsorting is set to reject an image longer than a
defined length.
Length Too Short
Results when outsorting is set to reject an image shorter than a defined
length.
Gap Too Small
Results when the gap between pieces is shorter than the minimum feed
gap defined in the machine parameters.
Too Thin
Results when out sorting is set to reject a piece thinner than a defined
minimum allowable thickness.
Too Thick
Results when out sorting is set to reject a piece thicker than a defined
maximum allowable thickness.
Unable to Capture
Image
Results when the imager fails to capture the image within the period of
time that it is expected to.
Unable to Process
Image
Results when an image fails processing due to a failure other than running
out of processing time.
Blank Image
Detected
Results when a job is set to reject blank pages and the piece was
determined to be a blank page.
Does Not Match
Expected Page Types
Results when the system could not match a piece to any of the page types
in a particular job.
Bad MICR Read
Results when the result from the combined MICR read does not have
sufficient valid characters or a valid checksum.
To Next Page
Loading...
