3 Operational Maintenance
August 2010 AS3690 Operator Manual 3-1
Calibrating the Touch Screen Monitor
The monitor is calibrated for its touch sensitivity before it leaves OPEX. However, you
may need to recalibrate, especially if it is in use for an extended period of time.
To calibrate the monitor:
1 Go to Start > Settings > Control Panel.
- The Control Panel window appears.
2 Double-click Elo Touchscreen.
FIGURE 25: Elo Touchscreen Icon
3 Click Align.
4 Follow the instructions on the screen, using the monitor (not the mouse) to touch
the three targets.
- The Check Video Alignment dialog box appears.
NOTE: Make sure you touch the monitor’s surface. Do not use the mouse to
perform this step, as you are calibrating the monitor to touch.
5 Touch around the screen, making sure the cursor follows where you touch.
6 If the test was successful, touch Yes.
7 If the test was not successful, you are prompted to repeat the test. Complete Steps
3 through 6 again.
8 When finished, touch OK to close the Elo Touchscreen Properties window.
To Next Page
Loading...
