2 Operating the System
August 2010 AS-Series Operator Manual 2-25
Adjusting image quality
Fine-tune the quality of the document images by pressing Adjust on the Run screen.
The Adjust Capture Parameters screen will appear, where you can modify the
brightness and dropout colors for the images.
Table 1 describes the Adjust Capture Parameters screen buttons.
Rescanning documents
If you are not pleased with a particular image, you can rescan the document while
the job is running. To rescan a document:
1 Select the document’s thumbnail.
2 Take the document out of the sort bin.
3 Press Rescan to replace the document in the batch.
NOTE: If an audit trail was printed on the document the first time it was scanned,
press Rescan NP (no printing) to replace the document in the batch. This way,
no additional audit trails will be printed on the document.
4 Drop the document onto the drop feeder.
5 Verify that the image is acceptable.
NOTE: The Rescan buttons will only be available if activated for the current job.
TABLE 1: Adjust Capture Parameters screen buttons
Brightness
Adjust the brightness of the document images from Light to Dark. Press a button
to adjust the brightness. The default is
Normal.
Dropout
Remove a dropout color (Red, Green, Blue, or White) from the document image.
The color you select will appear as white. The default is
White.
NOTE: To use this feature, the documents must be printed with a specific
dropout color.
Adjust All/
Adjust One
Select Adjust All to apply these changes to all the documents in the current job,
or
Adjust One to make the adjustments only to the next document scanned.
Defaults
Return to the default capture parameters.
To Next Page
Loading...
