A Statistics
A-2 AS3690 Operator Manual August 2010
2 For this exercise, click the Summary Report button at the bottom of the screen.
3 In the Statistics Reports Criteria window, set the parameters for the report as
shown in Figure 32:
- Jobs - select the job(s) for which you want to run a statistics report.
- You can select several individual jobs for a single report, however, if you
click All Jobs, it automatically deselects the individual jobs (since they would
be included in the “All Jobs” category).
- Operators - select the operator(s) and/or the shift for which you want to run a
statistics report.
- You can select several individual operators for a single report, however, if
you click All Operators, it automatically deselects the individual operators
(since they would be included in the “All Operators” category).
- Clicking any one of the Shift options will select all operators during that
scheduled shift. The default setting, All Operators, includes all shifts.
- Date - set the start and end date for the report. In Figure 33, the Summary
report was run for a single day, but virtually any range can be selected.
- Time - set the start and end time for the report. In Figure 33, these parameters
were set to include the 3rd shift (12:00 AM-8:00 AM) and the first shift (8:00
AM to 4:00 PM).
- Job/Operator Lists - select one of the radio buttons:
- Current jobs/operators - To use the job names and operators currently stored in
the Controller’s memory (as shown in the Jobs and Operators lists).
- Read thru previous runs - To find runs deleted from the current list of jobs and
operators. For example, if a job file was deleted from the Job Name frame, it
is still stored in the stats file. You can access it by selecting this radio
button, then clicking the Refill button.
4 In the Summary section, select one of the radio buttons:
- All - to generate a statistics report for every job run that matches the
selected criteria
- Jobs - to generate a statistics report sorted by job name(s)
- Operators - to generate a statistics report sorted by Operator name(s)
- Check the box to exclude jobs run by the OPEX Technician in your report.
5 Click the Test Matching Runs button to see how many jobs have been run that match
the criteria selected above. If N/A appears to the right of the button, then there are
no jobs to report that match the criteria listed.
- If a number appears after the Matching Runs button, clicking Ok will generate a
statistics report for the selected criteria.
To Next Page
Loading...
