A Statistics
A-8 AS3690 Operator Manual August 2010
The Jams section lists the reasons for the jams that occur.
Failed Saving Image
Results when there is an error trying to add or rescan a piece to a batch.
Magnetic MICR
Response Missing
Results when the software does not receive a response from the magnetic
MICR when it is expecting one.
Cannot Process
Printer Data
Results when there is an error in sending the audit trail information down
to the printer.
Required Item
Expected
Results when an item is of the wrong priority to be scanned in the current
location within a transaction. (Structured batches only.)
Only One Item of this
Type Expected
Results when only one item of the scanned item's priority is allowed, and
that required item is already present within the batch. (Structured batches
only.)
New Transaction
Required
Results when a new transaction must be started in order to add this item to
the batch. (Structured batches only.)
Jamsorts
All input pieces immediately following a reject when the job parameter
"Stop Machines for Rejects" is set to something other than 'No' until the
reject is cleared. All input pieces immediately following a jam until the jam
is cleared.
TABLE 6: Reasons for jams
Too Many
Consecutive Rejects
Results when the number of consecutive rejects is greater than the
machine parameter maximum consecutive reject count.
Software Problem
Detected
Results when the controller receives invalid information from CertainScan
or there is an assert or exception within the controller.
Vertical Turn Sensor
Missing
Results when the controller is expecting to see a piece pass by the vertical
turn sensor but it has not within the time period that we are expecting it.
Stacker Entry Sensor
Missing
Results when the controller is expecting to see a piece pass by the stacker
entry sensor but it has not within the time period that we are expecting it.
Bin 2 Gate Sensor
Missing
Results when the controller is expecting to see a piece pass by the bin 2
gate sensor but it has not within the time period that we are expecting it.
Bin 3 Gate Sensor
Missing
Results when the controller is expecting to see a piece pass by the bin 3
gate sensor but it has not within the time period that we are expecting it.
Bin 4 Gate Sensor
Missing
Results when the controller is expecting to see a piece pass by the bin 4
gate sensor but it has not within the time period that we are expecting it.
Bin 5 Gate Sensor
Missing
Results when the controller is expecting to see a piece pass by the bin 5
gate sensor but it has not within the time period that we are expecting it.
Unexpected Piece at
Stacker Entry Sensor
Results when a piece is detected at the stacker entry sensor that the
software was not expecting. This is usually caused by a piece that was
intended to go to the stacker bypass bin but did not make the correct
decision in time. A gate that did not fire properly can also cause it.
TABLE 5: Reasons for rejected items (Continued)
To Next Page
Loading...
