47
Falcon User Manual - Remittance Processing - OPEX Corporation
Additional information windows
There may be additional information tabs that appear in the Run screen
window, based on job setup. These tabs include:
MultiAssist
The MultiAssist tab appears if the job is set up to use the optional Multi-Slot
IdAssist feature, and displays information regarding which slot, swipe method,
and action has been programmed for the job.
Reference IDs
Shows the reference IDs defined for the running job. Not visible if reference IDs
are not defined. The values in this panel indicate how subsequent pieces will
be noted. It also indicates how the batch will be noted. Since the RefIDs for a
batch are not finalized until the batch is closed, batch RefIDs may be changed
at any time. Page RefIDs, however, may only be changed by rescanning the
piece in question.
ScanLink
This panel is controlled by the ScanLink plug-in for the running job. This panel
is not visible if a plug-in is not defined.
WholesaleWorks 0
This panel is controlled by the ScanLink plug-in for the running job. This panel
is visible if the plug-in requests it. This panel is also labeled by the plug-in.
WholesaleWorks 1
This panel is controlled by the ScanLink plug-in for the running job. This panel
is visible if the plug-in requests it. This panel is also labeled by the plug-in.
To Next Page
Loading...
